Cisco 521G - Unified IP Phone VoIP Configuration Manual page 41

Chapter 3 Creating and Connecting to a Community
CCA starts in a disconnected mode, it is not connected to a community or a standalone device. In this
mode, you see the menu bar in the CCA window and only the Setup and Monitor options of the feature
bar. The feature bar is populated with device features only when CCA is connected to a community.
The Connect window gives you these choices:
• Creating a new community. You first create the community and then connect to it.
• Connecting to an existing community or to a standalone device.
• Working offline. When you are offline, only the Voice feature is available on the feature bar. You
can specify options for voice communication, save them, and retrieve them in a later session, when
you do connect to a community or a standalone device.
To use the Connect window to create a new community of devices, follow these instructions:
Check Create community in the Connect window (see
Step 1
Figure 3-1
Click OK and the Create Community window appears (see
Step 2
OL-15283-01
Connect Window
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
Creating a Community of Devices Using the Connect Window
Figure 3-1).
Figure 3-2).
3-3