Cisco 521G - Unified IP Phone VoIP Configuration Manual page 34

Adding a New Controller
Step 9 For the management interface, perform these operations:
Enter the IP address of the management interface.
a.
Accept the default subnet mask or enter a new subnet mask in the Subnet Mask field.
b.
Enter the IP address of the default gateway (or router) in the Default Gateway field.
c.
Note
Accept the default controller port 1 setting or click the drop-down arrow to choose port 2. These
d.
ports are located on the controller front panel and are used to connect the controller to the network.
Enter the IP address of the DHCP server in the DHCP Server IP Address field.
e.
Note
For the AP Manager interface, enter the IP address for the AP Manager in the IP Address field.
f.
Click Next and the Step 9 Summary window appears (see
g.
Figure 2-11
Carefully review the summary settings and perform one of these operations:
Step 10
If the summary is incorrect or you desire to make changes, click Previous and the previous window
a.
appears.
If the summary is correct, click Finish and the wizard begins to transfer the configuration
b.
information to the controller (a progress bar appears). When the transfer is complete, the wizard
indicates the finish status on the window (see
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
2-8
The VLAN identifier is set to 0 for an untagged VLAN. This setting cannot be changed with
the CCA. This setting must be the same on the switch.
The default for the Transport Mode is Layer 3 and cannot be changed with the CCA.
Step 9 Summary Window
Chapter 2 Adding a WLC526 Controller and LAP521 Access Points
Figure 2-11).
Figure 2-12).
OL-15283-01