Adding Lap521 Access Points - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Chapter 2 Adding a WLC526 Controller and LAP521 Access Points
Step 4 After verifying the IP address of your Ethernet adapter, close the window by clicking the Red X box.

Adding LAP521 Access Points

Each WLC526 controller supports up to six controller-based LAP521 access points. For additional
information on mounting the access points, refer to the Quick Start Guide: Cisco 521 Wireless Express
Access Point at this Cisco.com URL:
http://www.cisco.com/en/US/docs/wireless/access_point/521/quick/guide/a521qsg.html
You must connect your LAP521 access points to a switch to enable communications with a controller.
The WLC526 controller supports only controller-based LAP521 access points. It does not support Cisco
Note
Aironet lightweight access points, such as the 1000, 1130, 1200, 1240, 1250, 1300, 1500, or 1520 series
access points.
Note The switch ports to which you connect your access points must be configured as access point smart
ports. You can use CCA or the switch web-browser interface to configure the switch ports.
The access points can be powered by PoE from your switch, by a power injector, or by a power module.
On power up, the access points begin a discovery process that automatically connects them with your
controller. The discovery process is indicated by the Status LED indicator on the access point blinking
green, red, and amber. When the access point associates with the controller, the Status LED changes to
light green. For more information about the LED color codes, refer to the Quick Start Guide: Cisco 521
Wireless Express Access Point.
When the LAP521 associates to the WLC526, the controller automatically downloads the latest
operating system and configures the access point.
OL-15283-01
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
Adding LAP521 Access Points
2-11