Chapter 2
Adding a WLC526 Controller and LAP521 Access Points
Adding a New Controller
Figure 2-1
CCA Window
For additional information about the CCA interface, windows, icons, or menus, refer to Getting Started
with Cisco Configuration Assistant 1.5.
Adding a New Controller
You can use CCA to add and configure your controller. CCA provides a device setup wizard to simplify
the configuration process.
The CCA device setup wizard only supports WLC526 Release 4.2 controllers.
Note
The Ethernet adapter on your PC must be configured to automatically receive an IP address from a DHCP
server (see the
"Verifying and Configuring Your Ethernet Adapter" section on page
2-9).
Follow these instructions to use the device setup wizard to configure a new controller:
Step 1
To start the wizard, click Setup > Device Setup Wizard. The Step 1: Select a Device window appears
(see
Figure
2-2).
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
2-2
OL-15283-01