Functional Description; Installing Or Removing Battery Cartridge - Makita DCU601 Instruction Manual

FUNCTIONAL
DESCRIPTION
Installing or removing battery
cartridge
CAUTION:
Always switch off the machine and
lock the brake lever before installing or removing
of the battery cartridge.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the machine, causing
injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
CAUTION:
Do not use the high-temperature
battery cartridge. When the high-temperature bat-
tery cartridge is used, the machine stops automati-
cally before a short beep sound is emitted, and may
cause an injury.
CAUTION:
Be careful not to pinch your fin-
gers when opening or closing the battery cover.
NOTICE:
Make sure that the cover of the battery
box is closed securely before use. Otherwise, mud,
dirt, or water may cause damage to the product or the
battery cartridge.
Installing the battery cartridge
1. Pull up the lock lever, and then open the cover of
the battery box.
Fig.2
► 1. Cover 2. Lock lever
2. Align the tongue on the battery cartridge with the
slot on the battery box, and then slide the cartridge until
it locks in place with a little click.
Fig.3
► 1. Battery cartridge
3.
Insert the lock key in the place shown in the figure
as far as it will go, and turn it clockwise.
Fig.4
► 1. Lock key
NOTE: To turn the lock key, insert the lock key
completely.
4.
Close the cover of the battery box.
1
2
Fig.5
► 1. Cover
11 ENGLISH
1
1
1