Intended Use - Makita DCU601 Instruction Manual

Do not directly look into lamps.
Do not wash the machine with high
pressure washer.
Keep bystanders away from the
machine during operation.
Do not operate the machine around
uneven surfaces.
Do not operate the machine
when the carrier is not returned
completely.
Always wear non-slip and protective
footwear.
Lock the brake before pulling out the
❶ ❷
neutral change lever.
Lock the brake before returning the
❶ ❷
neutral change lever.
Air pressure: front tire 280 kPa and
rear tire 525 kPa.
When a beep sound is emitted, lock
the brake lever.
When you release the switch trigger,
lock the brake lever.
To cancel the beep sound, release
the switch trigger and pull the brake
lever.
Only for EU countries
Ni-MH
Due to the presence of hazardous com-
Li-ion
ponents in the equipment, waste electrical
and electronic equipment, accumulators
and batteries may have a negative impact
on the environment and human health.
Do not dispose of electrical and
electronic appliances or batteries
with household waste!
In accordance with the European
Directive on waste electrical and elec-
tronic equipment and on accumulators
and batteries and waste accumulators
and batteries, as well as their adaptation
to national law, waste electrical equip-
ment, batteries and accumulators should
be stored separately and delivered to a
separate collection point for municipal
waste, operating in accordance with the
regulations on environmental protection.
This is indicated by the symbol of the
crossed-out wheeled bin placed on
the equipment.

Intended use

The machine is intended for loading, carrying, and lifting
up objects with battery powered assistance.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-1 and EN12053 as applicable:
Sound pressure level (L
Uncertainty (K) : 4 dB (A)
The noise level under working may exceed 80 dB (A).
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-1:
Work mode: operation without load
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
3 ENGLISH
Guaranteed sound power level
according to EU Outdoor Noise
Directive.
Sound power level according to
Australia NSW Noise Control
Regulation.
) : 70 dB(A) or less
pA
2
) : 2.5 m/s or less
h
2