Table of Contents
Advertisement
Unlatch dust collector motor (see Figure 9),
9.
lift dust collector out of canister, and set it
aside.
Dust Collector
Motor Latch
In-line Plug
Figure 9. Dust collector.
10. Working from inside of canister, insert canis-
ter plunger through canister wall so it can be
seen protruding from outside of canister.
11. Place spring on plunger shaft, and thread
jam nut and knob onto plunger, as shown in
Figure 10.
Knob
Jam Nut
Figure 10. Canister plunger.
-18-
x 4
Suction
Port
Spring &
Plunger
12. Re-install dust collector into canister.
13. Using 10mm wrench, tighten jam nut against
knob.
14. Using silicone (not supplied), seal gap
between suction port and hole in cabinet wall
(see Figure 11).
Gap
Figure 11. Dust collector suction port.
15. Re-install baffle.
16. Install (4) door hinges on cabinet body with
(8) M6-1 x 12 Phillips head screws and M6-1
flange nuts (see Figure 12).
x 8
Figure 12. Mounting locations for door hinges.
Model G0707 (Mfd. Since 12/23)
Door Hinge
(1 of 4)
Advertisement
Table of Contents
