Makita PM001GZ Instruction Manual page 18

4. When not using the battery cartridge, remove
it from the tool or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).
ASSEMBLY
CAUTION:
Always be sure that all the battery
cartridges are removed before carrying out any
work on the machine. Failure to remove all the bat-
tery cartridges may result in serious personal injury
from accidental start-up.
Assembling blower pipes
1. Loosen the clamp screw.
► Fig.2: 1. Clamp screw
2. Install the control handle to the swivel pipe and
tighten the clamp screw.
► Fig.3: 1. Control handle 2. Swivel pipe 3. Clamp
screw
NOTICE:
Be careful not to twist the cable of the
control handle when attaching the control handle
to the swivel pipe.
Loosen the screw on the hose clamp, and then
3.
attach the hose clamp to the end nozzle. Align the
grooves on the end nozzle with the protrusions on the
swivel pipe, then attach the end nozzle to the swivel
pipe, and then tighten the screw on the hose clamp.
► Fig.4: 1. End nozzle 2. Hose clamp 3. Swivel pipe
4. Groove 5. Protrusion 6. Screw
Loosen the screw on the hose clamp, then attach
4.
the nozzle lever to the hose clamp, and then attach the
hose clamp to the flexible pipe. Attach the swivel pipe to
the flexible pipe, and then tighten the screw on the hose
clamp.
► Fig.5: 1. Swivel pipe 2. Nozzle lever 3. Hose clamp
4. Flexible pipe 5. Screw
Loosen the screw on the hose clamp, and then
5.
attach the hose clamp to the flexible pipe. Attach the
flexible pipe to the elbow, and then tighten the screw on
the hose clamp.
► Fig.6: 1. Flexible pipe 2. Hose clamp 3. Elbow
NOTICE:
Make sure that the screw on the hose
clamp is not facing outward as shown in the
figure.
► Fig.7: 1. Screw
Clamp the control cable to the cable holders.
6.
► Fig.8: 1. Cable holder 2. Control cable
NOTICE:
Make sure that the control cable is
securely fixed to the cable holder.
Adjusting the belt and shoulder
harness
Put on the machine, then lock the buckle of the
1.
waist belt, and then adjust the length of the waist belt.
► Fig.9: 1. Buckle
Adjust the length of the shoulder harness.
2.
► Fig.10: 1. Shoulder harness
Adjusting the control lever position
Loosen the clamp screw. Move the control handle along
the swivel pipe to the most comfortable position, and
then tighten the clamp screw.
► Fig.11: 1. Control handle 2. Swivel pipe 3. Clamp
screw
Attaching the diffusion cover
You can diffuse the mist by attaching the diffusion cover
to the end nozzle as shown in the figure.
► Fig.12: 1. Diffusion cover
Attaching the deflector
Optional accessory
You can discharge the mist upward or downward by
attaching the deflector to the end nozzle as shown in
the figure.
► Fig.13: 1. Deflector
18 ENGLISH