Advertisement
Accessories
(depending on model)
Charging Travel Case (h)
• To charge your handle (5) place it in the
charging travel case (h) and connect it to
an electric outlet, using the extra power
supply (h2) provided. The power supply
may be used for all global mains voltage
ranges (100 – 240V).
• The charging light (h1) of the charging
travel case indicates that the handle is
charging. Once the handle is fully charged
the light turns off. A full charge typically
takes 6 hours.
• The outer and inner case should be cleaned
with a damp cloth only. Make sure that the
handle and brush head are completely dry
before storing in the travel case.
Note: Clean stains on travel case surface
immediately. Store travel case in a clean and
dry place.
Travel Case (g)
Store the clean and dry toothbrush/brush
heads in the travel case (g).
The outer and inner case should be cleaned
with a damp cloth only.
Note: Clean stains on travel case surface
immediately. Store travel case in a clean and
dry place.
Brush head holder stand (f) / Brush head
holder with cap (e)
You may store your cleaned brush heads on
the pins of the brush head holders. Make sure
brush heads are dried before placing them in
the holder and/or closing the cap. Brush head
holders and cap are dishwasher-safe.
Zipper Pouch / Magnetic Pouch
Store the clean and dry toothbrush/brush
heads in the zipper pouch.
The outer and inner case can be cleaned
under running water.
Store the clean and dry toothbrush along with
the brush head holder (e) in the magnetic
pouch. Make sure brush heads are dried
before placing them into the holder and/or
closing the cap. The outer and inner surfaces
can be cleaned under running water. Store
pouches in a clean and dry place.
Note: Clean stains on pouch surfaces immedi-
ately.
Subject to change without notice.
Environmental Notice
Product contains batteries and/or
recyclable electric waste. For envi-
ronment protection do not dis-
pose in household waste, but for recycling
take to electric waste collection points
provided in your country.
Battery removal at the end of the product's
useful life
Do not disassemble the product except when
disposing of the battery. Run down battery
before removing. When taking out the battery
for disposal, use protective clothing (gloves,
safety glasses, etc.) to omit skin contact
whilst leaking batteries. Use caution not to
short the positive (+) and negative (–)
terminals. Insulate terminals (e.g. with tape)
and put the battery in a plastic bag for
disposal.
1
4
2
45°
3
6
Li-ion
5
7
19
Advertisement
