Makita DCU603 Instruction Manual page 14

7. Attach the cord cover.
1
Fig.14
► 1. Cord cover
Removing the dump unit
To remove the dump unit, perform the installation proce-
dure in reverse.
Installing or removing the bucket
Optional accessory
Installing the bucket
1. Take out the bucket, stays, and front pipe from the box.
Fig.15
► 1. Bucket 2. Stay 3. Front pipe
2. Insert the front pipe between the upper frame and
lower frame of the dump unit.
1
Fig.16
► 1. Front pipe
1
2
3
14 ENGLISH
3. Place the stay on the dump unit, and then tempo-
rarily tighten the bolts with the front pipe together. Install
the other stay to the dump unit in the same way.
1
2
Fig.17
► 1. Stay 2. Bolt
4. Place the bucket on the front pipe and left and
right stays.
Place the rubber washer on the hole of the bucket and
insert the bolt from the top. Attach the flat washer and
spring washer in order to the bolt, and then tighten the
nut from the bottom. Tighten the rest of the bolts and
nuts in the same way.
1
2
3
4
5
Fig.18
► 1. Bolt 2. Rubber washer 3. Flat washer 4. Spring
washer 5. Nut
5.
Securely tighten 4 bolts which were temporarily
tightened in step 3.