Black & Decker BCL101 Instructions Manual page 9

- GoPak Charge Input: Up to 2.4A**
- GoPak Power Output: Up to 2.4A***
** Actual input charge rate is dependant
upon power adapter (not included).
***Actual output rate is dependant on the
device.
USB power port
The BLACK+DECKER GoPak 2 in 1 battery is
equipped with a USB Type A power port. It
delivers up to 2.4 amp total current.
Note: The current delivered to device is
dependent on user device and user's chosen
cable.
Warning: Ensure the terminal cap
is securly attached to the
BLACK+DECKER GoPak 2 in 1
battery when using it to
power/charge your device.
• Install terminal cap on the tool terminals.
• Device charging from USB will start
automatically when device is connected.
• To turn OFF, disconnect USB device.
Proper hand position (Fig. H)
Warning: To reduce the risk of
serious personal injury, ALWAYS
use proper hand position as
shown.
Proper hand position requires one hand on
the main handle.
Fig. H
All manuals and user guides at all-guides.com
(Original instructions)
On/o button (fig. A)
1. To turn the light on, press the on/o
button 1 .
2. To turn it o , press the button again.
Pivoting The Light Housing (Fig. I, J)
1. The LED light housing (2) can be pivoted
by lifting it to di erent positions within
the 90 degree pivot range.
2. The LED flashlight can also be positioned
on the battery end to provide a greater
range of light coverage as shown in
Figure J.
Fig. I
Fig. J
2
ENGLISH
2
9