Black & Decker BCL101 Instructions Manual page 6

ENGLISH
The US Department of Transportation
Hazardous Material Regulations (HMR)
actually prohibit transporting batteries in
commerce or on airplanes in carry-on
baggage UNLESS they are properly
protected from short circuits. So when
transporting individual battery packs, make
sure that the battery terminals are
protected and well insulated from materials
that could contact them and cause a short
circuit.
Caution: GoPak battery terminal cap should
be used when battery is not connected to a
power tool. Terminal cap is provided for use
whenever the battery is out of the tool.
Remove cap before placing battery into
tool.
FCC requirements for all digital
devices
This device complies with Part 15 of the FCC
Rules and Industry Canada License-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority
to operate the equipment.
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment o and on, the user
is encouraged to try to correct the
interference by one of the following
meaures:
6
All manuals and user guides at all-guides.com
(Original instructions)
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on
a circuit di erent from that to which the
receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
CAN ICES-3(B)/NMB-3(B)
Getting started
• The micro USB port (7) on the
BLACK+DECKER GoPak 2 in 1 battery is
only to be used for charging the GoPak.
• The USB A port (14) on the
BLACK+DECKER GoPak 2 in 1 battery is
only to be used for powering USB devices
(Phone/Tablet/MP3/Wearable/Game
Controller/etc.).
Fig. B
14
Charging the BLACK+DECKER gopak 2
in 1 battery (Fig. C, D)
Warning: Never attempt to charge
the BLACK+DECKER GoPak 2 in 1
battery using the tool terminals on
the GoPak.
Warning: You should only charge
the BLACK+DECKER GoPak 2 in 1
battery using UL or CSA approved
USB ports rated for charging high
performance devices. The GoPak can pull
more current than acceptable with older
USB ports. An error message may display on
your computer if the computer is used to
charge the GoPak.
1. Plug the micro USB cable (8) into a USB
power supply (not included).
7