Black & Decker BCL101 Instructions Manual page 7

2. Plug the micro USB plug of your charger
cord into the GoPak micro USB port (7) .
3. As the GoPak charges, the state of
charge LEDs will illuminate. The
illuminated LED(s) indicate the state of
charge of the pack. The blinking LED
indicates the next level of charge in
progress. The state of charge button (9)
is disabled during charging only.
4. The completion of charge is indicated by
all four LEDs turning o . Pressing the
state of charge indicator button (9) will
illuminate all four LEDs. The battery is
fully charged and may be used at this
time or left on the charger.
5. Recharge discharged batteries as soon
as possible after use or battery life may
be greatly diminished. For longest
battery life, do not discharge batteries
fully. It is recommended that the
batteries be recharged after each use.
Fig. C
8
State of charge indicator (Fig. D)
The BLACK+DECKER GoPak 2 in 1 battery is
equipped with a state of charge button (9)
with a four LED display.
The state of charge is an indication of
approximate levels of charge remaining in
the battery according to the following
indicators:
96-100% charged
76-95%
51-75%
26-50%
Pack needs to be charged
All manuals and user guides at all-guides.com
7
(Original instructions)
To actuate the state of charge, press the
state of charge button. A combination of the
four LEDs will illuminate designating the
level of charge left. When the level of charge
in the battery is below the usable limit, the
state of charge Indicator LEDs will either not
light or the bottom LED will blink.
Note:
The LED state of charge will only
display once the state of charge button is
pressed.
Fig. D
• Press state of charge button at anytime
to display the remaining level of charge.
Note:
The state of charge is only an
indication of the charge left on the battery. It
does not indicate tool functionality and is
subject to variation based on product
components, temperature and end-user
application.
Note:
GoPak battery terminal cap should be
used when battery is not connected to a
power tool. Terminal cap is provided for use
whenever the battery is out of the tool.
Remove cap before placing battery into tool.
Save these instructions for future use
Components (Fig. A)
Warning:
tool or any part of it. Damage or
personal injury could result.
Refer to Figure A at the beginning of this
manual for a complete list of components.
Assembly and adjustments
Warning:
serious personal injury, turn unit o
and remove the battery pack before
making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
ENGLISH
9
Never modify the power
To reduce the risk of
7