Preface - Honeywell Enraf VITO 762 Installation Manual

Preface

This installation guide is intended for technicians involved in the mechanical and electrical
installation of the Honeywell Enraf series 76x and 36x temperature and/or water probes
and the 762 VITO Interface. There are three 762 VITO Interface versions:
VITO-MTT (16 elements) -> only to be used in combination with 764/765/766 probe;
VITO-LT (9 elements) -> only to be used in combination with 767/768 probe;
VITO-MRT (max. 14 elements) -> only to be used in combination with RTD/MRT/36x MPT
probe.
Note:
The 361 VITO MPT probe up to 6 Pt-100 elements can be directly connected to the
990 SmartRadar FlexLine without the need of a 762 VITO-MRT Interface.
The technician must have basic technical skills and knowledge of safety regulations and
explosion proof equipment in hazardous areas.
EC declaration of conformity
Refer to the EC declaration of conformity, shipped with the instrument.
Note:
The connection to the instrument must be made with shielded cable. The shielding
must be grounded in the cable gland on both ends of the cable.
Legal aspects
The mechanical and electrical installation shall only be carried out by trained personnel
with knowledge of the requirements for installation of explosion proof equipment in
hazardous areas.
The information in this installation guide is the copyright property of Enraf B.V.,
Netherlands. Enraf B.V. disclaims any responsibility for personal injury or damage to
equipment caused by:
 Deviation from any of the prescribed procedures;
 Execution of activities that are not prescribed;
 Neglect of the general safety precautions for handling tools, use of electricity
and microwave radiation.
The contents, descriptions and specifications are subject to change without notice.
Enraf B.V. accepts no responsibility for any errors that may appear in this installation
guide.
Additional information
Please do not hesitate to contact Honeywell Enraf or its representative if you require
additional information.
Installation guide 762 VITO interfaces & VITO probes
Preface
Page 3