Honeywell Enraf VITO 762 Installation Manual page 20

 Connect the other twisted pair of gauge wire the terminals on the lower left hand
side of the front (temperature) converter block:
pin 1: -
pin 2: +;
 Re-install the black plastic shield on the front converter block.
Figure 10 CEPS Interface for 365 MPT temperature and water probe
Note:
The 365 MPT temperature and water probe with the associated CEPS Interface
can only be used (connected) with an 990 SmartRadar FlexLine which contains
two FII-VT boards.
Installation guide 762 VITO interfaces & VITO probes
Electrical installation
Page 20