Honeywell Enraf VITO 762 Installation Manual page 15

 Unpack the VITO Interface (preferable on the tank);
 Remove the cover from the VITO Interface enclosure;
 Clean the inside thread of the upper IP adapter (3b) which is already attached to
the VITO housing;
 Apply a light, smooth layer of Agip TOP 2000 grease over the inside threads of
the upper IP adapter (3b) on the VITO Interface housing and over the outside
threads of the lower IP adapter (3a) on the probe;
 Feed the flying leads through the upper IP adapter (3b) on the VITO Interface
enclosure.
Note:
With 762 CEPS Interface and 365 Combi probe, it may be required to
remove the front (temperature) module to feed the flying leads into the
762 CEPS enclosure (refer to section 3.2.3 and figure 10);
Make sure the probe wiring is not damaged when mounting the VITO
 Turn the VITO Interface onto the VITO probe's lower IP adapter (3a);
 Prevent the VITO Interface from turning by tighten the two set screws (4) on the
upper IP adapter;
 When the electrical installation is carried out at a later stage, the cover of the
VITO Interface enclosure can be closed after verifying there is no wire or
cable in the gap between the shield and the enclosure. Make sure the cover
threading is clean – if needed clean the threading with an old tooth brush and
apply Agip TOP 2000 grease.
Before closing, inspect, clean and lightly grease with Agip TOP 2000 grease.
When closing, turn cover counter-clockwise till thread 'clicks' in place, then
Notes:
Make sure the cable gland is water tight – use Teflon
needed.
Use of a self-fusing silicone tape (such as rescue Tape
is recommended to protect the cable gland from the environment.
enclosure on the threaded pipe.
Do not damage the thread of the cover.
turn clockwise until cover is fully closed.
Installation guide 762 VITO interfaces & VITO probes
Mechanical installation
Caution
Caution
®
tape or a suitable pipe sealant if
®
) or a suitable pipe sealant
Page 15