Network To Network Vpn Tunnel Configuration Worksheet; Procedure 5-1: Configuring A Network To Network Vpn Tunnel - NETGEAR FVM318 Reference Manual

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall

Procedure 5-1: Configuring a Network to Network VPN Tunnel

Follow this procedure to configure a VPN tunnel between two LANs via a FVM318 at each end.
LAN A
IN TER N ET W LA N LO CA L
Cable/DSL ProSafeWirelessVPN Security Firewall
LNK
PWR TEST
ACT Enable
1 2 3 4
192.168.3.1
Figure 5-2: LAN to LAN VPN access from an
The sample configuration worksheet below is filled in with the parameters used in this procedure.
A blank worksheet is provided on

Network to Network VPN Tunnel Configuration Worksheet

IKE Tunnel Security Association Settings
Connection Name:
Local IPSec Identifier
PreShared Key:
Secure Association -- Main Mode or Aggressive Mode:
Perfect Forward Secrecy:
WAN Encryption Protocol:
DES, 3DES, or AES -128, -192, or -256
Wireless Encryption Protocol:
-- IPSec (DES, 3DES, or AES -128, -192, or -256)
-- WEP (64-bit or 128-bit)
Key Life in seconds:
IKE Life Time in seconds:
FVM318 Network IP Settings
Network
LAN A
LAN B
5-4
VPN Tunnel
FVM318
MODEL
100
LNK/ACT
5 6 7 8
page 5-22.
LAN IP Network Address Subnet Mask
192.168.3.1
192.168.0.1
Cable/DSL ProSafeWirelessVPN Security Firewall
FVM318 FVM318
to an
VPNAB
LAN_A
LAN A:
LAN_B
LAN B
r>T(h4&3@#kB
Main
Enabled
DES
N/A
3600 (1 hour)
28800 (8 hours)
Gateway IP (WAN IP Address)
255.255.255.0 24.0.0.1
255.255.255.0 10.0.0.1
LAN B
IN TER N ET W LA N LO CA L MODEL
LNK
100
PWR TEST
ACT Enable LNK/ACT
1 2 3 4 5 6 7 8
192.168.0.1
Virtual Private Networking
FVM318