Snmp-Server Enable Traps Multiusers; No Snmp-Server Enable Traps Multiusers; Snmp-Server Enable Traps Stpmode; No Snmp-Server Enable Traps Stpmode - NETGEAR ProSafe GSM7224 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

snmp-server enable traps multiusers

This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is
sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an existing
terminal interface session.
Default
Format
Mode

no snmp-server enable traps multiusers

This command disables Multiple User traps.
Format
Mode

snmp-server enable traps stpmode

This command enables the sending of new root traps and topology change notification traps.
Default
Format
Mode

no snmp-server enable traps stpmode

This command disables the sending of new root traps and topology change notification traps.
Format
Mode

snmptrap

This command adds an SNMP trap name. The maximum length of name is 16 case-sensitive
alphanumeric characters.
Default
Format
Switching Commands
Enabled
snmp-server enable traps multiusers
Global Config
no snmp-server enable traps multiusers
Global Config
Enabled
snmp-server enable traps stpmode
Global Config
no snmp-server enable traps stpmode
Global Config
The default name for the six undefined community names is
Delete.
snmptrap <name> <ipaddr>
202-10009-01_060204
8-31