User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
show spanning-tree interface
This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot/port> is the desired switch port. The following details are
displayed on execution of the command.
Format
Mode
Port mode
Port Up Time Since Counters Last Cleared Time since port was reset, displayed in
STP BPDUs Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent
STP BPDUs Received
RST BPDUs Transmitted Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
RST BPDUs Received
MSTP BPDUs Transmitted Multiple Spanning Tree Protocol Bridge Protocol Data Units
MSTP BPDUs Received Multiple Spanning Tree Protocol Bridge Protocol Data Units
show spanning-tree mst detailed
This command displays settings and parameters for the specified multiple spanning tree instance.
The instance <mstid> is a number that corresponds to the desired existing multiple spanning tree
instance ID. The following details are displayed.
Format
Mode
MST Instance ID
MST Bridge Priority
Time Since Topology Change in seconds
Topology Change Count Number of times the topology has changed for this multiple
Topology Change in Progress Value of the Topology Change parameter for the multiple
Switching Commands
show spanning-tree interface <slot/port>
Privileged EXEC and User EXEC
.
Enabled or disabled
days, hours, minutes, and seconds.
Spanning Tree Protocol Bridge Protocol Data Units received.
Rapid Spanning Tree Protocol Bridge Protocol Data Units
received.
sent
received.
show spanning-tree mst detailed <mstid>
Privileged EXEC and User EXEC
spanning tree instance.
spanning tree instance
202-10009-01_060204
8-77