Unit Set Up Group; Table 4-2 Controller Unit Group Function Prompts - Honeywell 7866 Operation And Maintenance Manual

Set Up Mode
4.3

Unit Set Up Group

Function Prompts
Table 4-2 lists all the function prompts in the Controller's Unit Set Up group. Table 4-3 lists all the
function prompts in the Indicator's Unit Set Up group.
Function Prompt
(Lower Display)
SECURITY Security Code
LOCKOUT Configuration Lockout
Analyzer Range Type
TYPE
Output 2 Type Selection
CUR OUT
Current Output 2,
RNG3SPAN
Range 3 Span
PWR FREQ Input Frequency Selection
DECIMAL Decimal Point Location
34 7866 Triple Range Digital H

Table 4-2 Controller Unit Group Function Prompts

Function Name
and CO Analyzer/Indicator - Operation and Maintenance
2 2
Selections or Range of Setting
(Upper Display)
0000 to 9999
NONE – Permits changes to all functions.
CALIB – Calibration group functions are
hidden from view.
UNIT – Parameters in the Unit Set Up group
cannot be changed, but the Alarms and
Communications group parameters are
changeable. (Calibration parameters cannot
be seen.)
VIEW – All parameters are read only.
(Calibration parameters cannot be seen.)
TRIPLE – Read only
4-20MA
0-20MA
0 - 100%
75 - 100%
100 - 75%
Sets the 4-20mA or 0-20mA for range 3 only
to either 0-100%, 75-100%, or 100 - 75%.
NOTE: The current output for ranges 1 and 2
is 4-20mA or 0-20mA over the span of 0-
100%.
60 HZ
50 HZ
XXX.X – One decimal place
XX.XX – Two decimal places
Factory
Setting
0
NONE
TRIPLE
4-20MA
0 - 100
60 HZ
XXX.X
9/06