Ce Conformity (Europe) - Honeywell 7866 Operation And Maintenance Manual

Introduction
1.6

CE Conformity (Europe)

This product is in conformity with the protection requirements of the following European Council
Directives: 73/23/EEC, the Low Voltage Directive, and 89/336/EEC, the EMC Directive. Conformity of
this product with any other "CE Mark" Directive(s) shall not be assumed.
Product Classification: Class I: Permanently connected, panel-mounted Industrial Control Equipment with
protective earthing (grounding) (EN61010-1).
Enclosure Rating: This controller must be panel-mounted with the rear terminals enclosed within the panel.
The front panel of the controller is rated at NEMA4X and IP66 when properly installed.
Installation Category (Overvoltage Category): Category II (EN61010-1)
Pollution Degree: Pollution Degree 2: Normally non-conductive pollution with occasional conductivity
caused by condensation. (Ref. IEC 664-1)
EMC Classification: Group 1, Class A, ISM Equipment (EN61326, emissions), Industrial Equipment
(EN61326, immunity)
Method of EMC Assessment: Technical File (TF)
Declaration of Conformity: 51453681
Deviation from the installation conditions specified in this manual, and the special conditions for CE
conformity in section 3.6, may invalidate this product's conformity with the Low Voltage and EMC
Directives.
ATTENTION
The emission limits of EN61326 are designed to provide reasonable protection against harmful interference when this
equipment is operated in an industrial environment. Operation of this equipment in a residential area may cause harmful
interference. This equipment generates, uses, and can radiate radio frequency energy and may cause interference to radio and
television reception when the equipment is used closer than 30 meters (98 feet) to the antenna(e). In special cases, when
highly susceptible apparatus is used in close proximity, the user may have to employ additional mitigating measures to further
reduce the electromagnetic emissions of this equipment.
WARNING
If this equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be
impaired.
10 7866 Triple Range Digital H and CO Analyzer/Indicator - Operation and Maintenance
2 2
9/06