Figure 4-6 Configuration Upload In Progress - Honeywell 7866 Operation And Maintenance Manual

Set Up Mode
Close the Ethernet configuration window and then single click on the "Online Configuration" button.
Then, click on the "Start" button. The P.I.E. Tool
from the controller as shown below:
Once the upload is complete, click on the "Ethernet & Email" Group. Configure your Ethernet and Email
parameters per Section 4.8.
Once you have changed the Ethernet settings and downloaded them to your controller, you will no longer
be able to communicate with it until you change the IP address in the P.I.E. Tool
IP Address.
You will also need to re-configure the Local Area Network (LAN) settings on your PC back to their
original settings. On some PCs and LANs, it is possible to simply allow the PC to get these settings
automatically via the DHCP server. Contact your Information Technologies (IT) representative to see if
this is available on your PC.
46 7866 Triple Range Digital H
®
should start uploading the configuration information

Figure 4-6 Configuration Upload in Progress

and CO Analyzer/Indicator - Operation and Maintenance
2 2
®
to the controller's new
9/06