Figure 4-1 Ethernet Configuration Screen - Honeywell 7866 Operation And Maintenance Manual

Set Up Mode
representative as to how these should be configured for your installation. The MAC address is printed on
the product label located on the instrument's case.
These settings can be changed via the Ethernet Configuration Screen as shown in Figure 4-1.
See Section 4.9 – Configuring your Ethernet Connection for more information.
WARNING
After you change the IP Address, you will no longer be able to communicate with the instrument via
Ethernet until you change the P.I.E. Tool's IP Address setting in the "PC COMM SETUP" to match the
setting that is now in your controller.
Email Configuration Screen
This controller may be configured to support up to two Emails. Each Email can be sent to a different
address. Emails are sent only when the selected alarm transitions from the OFF to the ON state.
40 7866 Triple Range Digital H

Figure 4-1 Ethernet Configuration Screen

and CO Analyzer/Indicator - Operation and Maintenance
2 2
9/06