Connecting To The Controller Via Ethernet Communications - Honeywell 7866 Operation And Maintenance Manual

Set Up Mode

4.9.2 Connecting to the Controller via Ethernet Communications

WARNING
Connecting to the Controller via Ethernet Communications requires that you change your PC's IP settings.
If you have never done this before, then it is strongly recommended that you consult with your Information
Technologies (IT) representative before proceeding.
First, write down the current IP Address, Subnet Mask and Default Gateway settings for your PC. Put these
someplace that you can find them later.
Connecting to the Ethernet Port in the Controller requires that you have either an Ethernet crossover cable
or a MDI-compliant Switch or Hub available with a straight-through cable. The crossover cable can be
used to directly connect your PC to the Controller while the Switch or Hub can be used to connect your PC
and Controller to the Hub or Switch via straight-through cables.
Once you have made an Ethernet connection between your PC and the controller, then change the Local
Area Network (LAN) settings on your PC to be as follows:
IP Address: 10.0.0.3
Subnet Mask: 255.255.255.0
Default Gateway: 10.0.0.1
44 7866 Triple Range Digital H and CO Analyzer/Indicator - Operation and Maintenance
2 2
9/06