Table 4-3 Indicator Unit Group Function Prompts - Honeywell 7866 Operation And Maintenance Manual

Function Prompt
(Lower Display)
SECURITY Security Code
LOCKOUT Configuration Lockout
Analyzer Range Type
TYPE
BIAS R1 Bias of Input Value for Range 1
BIAS R2 Bias of Input Value for Range 2
BIAS R3 Bias of Input Value for Range 3
PV INPUT Selection of Input actuation
consistent with analyzer CUR
OUT selection
RNG3SPAN Selection of Input Range 3 to be
consistent with similar function
in the Analyzer.
For Range 3, it applies 1-5V or
0-5V over the range of 0-100%,
75-100%, or 100 - 75%.
Input Frequency Selection
PWR FREQ
DECIMAL Decimal Point Location
9/06 7866 Triple Range Digital H

Table 4-3 Indicator Unit Group Function Prompts

Function Name
and CO Analyzer/Indicator - Operation and Maintenance
2 2
Selections or Range of Setting
(Upper Display)
0000 to 9999
NONE – Permits changes to all functions.
CALIB – Calibration group functions are
hidden from view.
UNIT – Parameters in the Unit Set Up group
cannot be changed, but the Alarms and
Communications group parameters are
changeable. (Calibration parameters cannot
be seen.)
VIEW – All parameters are read only.
(Calibration parameters cannot be seen.)
TRIPLE – Read only
INDICTR – Read only
+10.00 to –10.00
+10.00 to –10.00
+10.00 to –10.00
1-5V (4-20mA)
0-5V (0-20mA)
0 - 100%
75 - 100%
100 - 75%
60 HZ
50 HZ
XXX.X – One decimal place
XX.XX – Two decimal places
Set Up Mode
Factory
Setting
0
NONE
TRIPLE
0.00
0.00
0.00
1-5V
0-100
60 HZ
XXX.X
35