Grizzly G0526A40 Owner's Manual page 22

Note: There is a small, plastic pin in under-
side of fence (see Figure 21). This pin should
slide along table or carriage base to prevent
fence from scraping table.
Figure 21. Location of plastic fence support pin.
16. Install fence tilt lever (see Figure 22).
Figure 22. Fence tilt lever installed.
-20-
Fence Support
Pin
Tilt Lever
Cutterhead guard must always return to
closed position whenever it is moved. If it
does not do this, it must be re-adjusted or
re-installed.
17. Remove scrap wood installed in Step 14 and
test operation of guard by pulling it back.
Guard should spring back over cutterhead
and stop against fence.
— If guard does not snap back, or snaps back
slowly, proceed to Checking/Adjusting
Cutterhead Guard on Page 46 before
continuing to Step 18.
18. Install fixed handles on both handwheels,
then install outfeed/infeed table handwheels
using (2) 10-24 x
head screws and #10 flat washers (see
Figure 23).
Fixed
Handle
Figure 23. Table handwheel installed.
Model G0526A40 (Mfd. Since 12/22)
⁄ " pre-installed Phillips
1
2
Outfeed/Infeed
Table Handwheel