Table of Contents
Advertisement
7.
Loosen set screws on cutterhead or motor
pulley as needed to align pulleys, then tighten
set screws (see Figure 13).
Pulley
Figure 13. Motor pulley set screw locations.
8.
Loosen motor mount hex nuts shown in
Figure 14, but DO NOT completely remove
them.
Figure 14. Location of motor mount hex nuts.
-18-
9.
Slide motor upward, place belt around
cutterhead and motor pulleys, then slide
motor down to rest on belt (see Figure 15).
x 2
Figure 15. Example of belt installed onto
10. Adjust belt tension by applying downward
pressure on motor until there is approxi-
mately
moderate force, as shown in Figure 16.
Note: After first 16 hours of operation, check
and re-tension belt as it may stretch and seat
during this time, causing it to lose initial ten-
sion setting.
Cutterhead Pulley
x 4
Approximately
/
1
4
Motor Pulley
Figure 16. Correct belt deflection when properly
11. Tighten motor mount hex nuts (see Figure 14)
and replace rear panel.
Belt
cutterhead and motor pulleys.
⁄
" deflection when belt is pushed with
1
4
" Deflection
tensioned.
Model G0526A40 (Mfd. Since 12/22)
Advertisement
Table of Contents
