Specifications - Makita AT638A Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Air pressure
Staple length
Staple capacity
Minimum hose diameter
Pneumatic tool oil
Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
Symbols
The followings show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
Wear safety glasses.
The tool has the capability of operating in
contact actuation mode.
Wear ear protection.
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for fastening on interior work and
furniture work.
The tool is for high-volume professional application
only. Do not use it for any other purpose. It is not
designed to drive fasteners on a hard surface like steel
and concrete.
Noise
The typical A-weighted noise level determined accord-
ing to ISO11148-13 (EN12549):
Sound pressure level (L
Sound power level (L ) : 114 dB (A)
WA
Uncertainty (K) : 1.5 dB(A)
) : 102 dB(A)
pA
0.49 - 0.83 MPa (4.9 - 8.3 bar)
ISO VG32 or equivalent
230 mm x 75 mm x 251 mm
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also be
used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual use
of the power tool can differ from the declared value(s)
depending on the ways in which the tool is used espe-
cially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as the
times when the tool is switched off and when it is run-
ning idle in addition to the trigger time).
Vibration
The vibration total value determined according to
ISO11148-13 (ISO8662-11):
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
WARNING:
The vibration emission during
actual use of the power tool can differ from the
declared value(s) depending on the ways in which
the tool is used especially what kind of workpiece
is processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
5 ENGLISH
AT638A
13 mm - 38 mm
100 pcs.
6.5 mm
1.2 kg
2
) : 5.0 m/s
h
2