Disabling Static Wep; Using Leap - Cisco Aironet 340 Series Installation And Configuration Manual

Chapter 4 Enabling Security Features
Step 6 Re-enter the new password in the Confirm New Password field.
Step 7 Click OK to save your new password or click Cancel to exit the screen without changing the password.
If your password is accepted, the following message appears, "Password Successfully Changed."
Step 8 Click OK to exit the utility.

Disabling Static WEP

Follow the steps below if you ever need to disable static WEP.
Step 1 Double-click the Cisco ACU icon or select Start > Programs > Cisco > Aironet Client Utility. The
ACU screen appears (see
Step 2 Select WEP under Property. Select Disabled from the list of options in the Value box to disable WEP.
Step 3 Click OK to save your changes and to exit the utility.

Using LEAP

This section provides instructions for enabling LEAP and entering the LEAP username and password.
Note LEAP is supported only on client adapters that support WEP and use firmware version 4.13 or
greater.
Note In order to use LEAP authentication, your client adapter and access point firmware must have
matching 802.1X draft standards. That is, if the access point uses draft 8 firmware (prior to 11.06) or
has draft 8 selected, the client adapter must use draft 8 firmware (prior to 4.25.x). Similarly, if the
access point uses draft 10 firmware (11.06 or later) and has draft 10 selected, the client adapter must
use draft 10 firmware (4.25.x or later).
OL-1375-02
Figure 4-5).
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Using LEAP
4-11