Cisco Aironet 340 Series Installation And Configuration Manual page 117

Appendix E Performing a Site Survey
Table E-2
Parameter
Percent Success Threshold
Data Retries
Tx Type
Step 2 After setting any parameters, click OK to save the settings. The Site Survey - Passive screen appears (see
Figure
Click the Start button to run the site survey test. The Site Survey - Active screen appears (see
Step 3
Figure
OL-1375-02
Site Survey Active Mode Parameters (continued)
Description
The percentage of packets that are not lost.
This parameter controls the red line on the Percent Successful
histogram. Percentages greater than or equal to this value are displayed
as green bars; percentages below this value are displayed as yellow
bars.
Range: 0 to 100%
Default: 75
The number of times a transmission will be retried if an
acknowledgment (Ack) is not returned by the destination device.
Default: None
Retry Value
None
Default Retries
The packet type that will be transmitted during the test.
Default: Unicast
Packet Type
Unicast
Multicast
E-1).
E-3).
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Using Active Mode
Description
No retries will occur.
The firmware's default value for retries
(16) will be used.
Description
When unicast packets are used, the system
expects to receive an acknowledgment
from the destination, and retries can occur.
When multicast packets are used, no
packet retries occur during the test.
E-7