Honeywell FIre-LITe ALArms MS-9600LS Manual page 28

Product Description
Annunciator cover
with LCD display
Key switch shown in OFF/Locked position
Mounting

TheANN-80 can be surface or semi-flush mounted to a single, double or 4" square electrical box.
Select and remove the appropriate knockout(s), pull the necessary wires through the knockouts and
mount the annunciator in or on the wall depending on the type of installation desired.
The ANN-SB80KIT(-R/-B/-W) is an available mounting kit for the ANN-80 annunciator. The kit
comes with a surface backbox and surface wedge for angled viewing. The two pieces can be used
separately or can be stacked together.
The ANN-80 cover must be attached to the annunciator backplate before mounting the annunciator
to the electrical box/wall. The cover cannot be reattached or removed after the annunciator has
been mounted.
Annunciator mounted on
surface wedge from the
28
ANN-SB80KIT
Figure 1.5 ANN-80
Annunciator mounted on
surface backbox from the
ANN-SB80KIT
MS-9600LS Series Manual — P/N 52646:B2 2/12/2010
Accessories
Annunciator backplate
Press in latch
and
Pull annunciator
cover open
Annunciator mounted on stacked
surface wedge and backbox from
the ANN-SB80KIT