Husqvarna FS 450 2015 Repair Manual page 122

16
BRAKE SYSTEM
Warning
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
Hazardous substances cause environmental damage.
-
Cover the painted parts.
-
Remove screw cap
-
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill
with fresh brake fluid.
Bleed syringe (50329050000)
Brake fluid DOT 4
-
Mount bleeder cover
I
Bleeder cover (00029013006)
-
Connect the bleeding device.
I
Bleeding device (00029013100)
-
Open shut-off valve
• Info
I
Follow the operating instructions of the bleeding device.
-
Ensure that the filling pressure is set on pressure gauge E). Adjust the filling
pressure on pressure regulator
I Guideline
Filling pressure
-
Pull off protection cap
bottle.
I
Bleeding device (00029013100)
-
Open bleeder screw
• Info
I
Drain until the fresh brake fluid emerges from the hose of the bleeder bot­
tle without bubbles.
-
Tighten the bleeder screw.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerging.
• Info
I
This prevents overfilling of the brake fluid reservoir.
-
Tighten the bleeder screw. Remove the hose of the bleeder bottle. Mount the pro­
tection cap.
-
Lock the bleeding device. Remove the bleeder cover.
O
with membrane and the O-ring.
(0 p. 228)
(0 p. 222)
@}.
(lii.,!l p. 226)
(0 p. 226)
8.
0
if necessary.
I
2 ... 2.5 bar (29 ... 36 psi)
C,
of the bleeder screw. Connect the hose of the bleeder
(0 p. 226)
0
by approx. one-half turn.
8.
120