Angle Adapter - Makita DGP180 Instruction Manual

Cartridge barrel
You can see the grease cartridge through the hole on
the cartridge barrel.
► Fig.30
When using the cartridge barrel, transfer the piston
parts from the corresponding barrel to the cartridge
barrel.
► Fig.31: 1. Piston parts 2. Cartridge barrel
If it is hard to pull out the rod handle, follow the proce-
dure below.
1. Insert the empty grease cartridge into the barrel.
► Fig.32: 1. Empty grease cartridge
2.
Pull the the rod handle and lock it.
► Fig.33
3. Remove the empty grease cartridge from the
barrel.
Lock on adapter
CAUTION:
Be careful not to pinch the finger
in the lock on adapter.
CAUTION:
Wear the protective goggles.
When removing the lock on adapter from the grease
nipple, the grease may spout out of the tool and
cause an injury.
When connecting the lock on adapter to the grease
nipple, push the lock on adapter straight at the grease
nipple while pulling the lever of the lock on adapter, then
release the lever.
► Fig.34: 1. Lever 2. Lock on adapter
To assemble the lock on adapter, refer to the section for
replacing of the adapter.

Angle adapter

When attaching the angle adapter, push the adapter of
the tool straight to the angle adapter.
► Fig.35: 1. Angle adapter
16 ENGLISH