Cisco ONS 15454 SDH User Manual page 4

15.4.1 E1-N-14 Card and E1-42 Card Performance Monitoring Parameters
Figure 15-1 Monitored Signal Types for the E1-N-14 Card and E1-42 Card
ONS 15454
SDH
Figure 15-2
produce performance monitoring parameters for the E1-N-14 card.
The E1-42 card uses the same PM read points. The only difference from the
Note
number of ports on the E1-42 equal 42.
Figure 15-2 PM Read Points on the E1-N-14 Card
ONS 15454 SDH
Tx/Rx
PMs read on LIU
The PM parameters for the E1-N-14 card and E1-42 card are described in
through
Cisco ONS 15454 SDH Reference Manual, R4.6
15-4
Near End
E1 Signal
E1 STM16
CRC4 Framing Path PMs Near + Far End Supported
VC-12 Low-Order Path PMs Near End Supported
shows where overhead bytes detected on the application-specific integrated circuits (ASICs)
E1 Card
LIU
Tx P-EB
Tx P-BBE
Tx P-ES
Tx P-SES
Tx P-UAS
Tx P-ESR
Tx P-SESR
Tx P-BBER
CV-L
ES-L
SES-L
Rx P-EB
Rx P-BBE
Rx P-ES
Rx P-SES
Rx P-UAS
Rx P-ESR
Rx P-SESR
Rx P-BBER
Table 15-4 on page 15-6.
Far End
Fiber
STM16
Framer
E1 Side
SDH Side
LP-EB
LP-BBE
LP-ES Low-
BTC
LP-SES
Order
LP-UAS Path
LP-ESR
Level
LP-SESR
LP-BBER
PMs read on Framer
Chapter 15 Performance Monitoring
E1 Signal
ONS 15454
SDH
E1
Figure 15-2
Cross-Connect
Card STM-N
Table 15-2 on page 15-5
is that the
April 2008