Cc (Cross Counting) - Cobra 57648 Owner's Manual & Safety Instructions

5. Use your mouse to click 2 points in the camera picture to draw a virtual line.
6. Click Save to save your settings.
7. If you want to modify the position or length of the line, click the red box in the line, the
color of the line will be changed to red color. Click and hold the left button of your mouse
to move the line, or drag the terminals to modify the length or position of the line.
8. If you want to remove one of the lines from the camera picture, click the red box in the
line and then click
Note:
1) The lines shall not be too close to the edges of the camera picture, to avoid any failure to
trigger an alarm when the target cross through it.
2) The lines shall not be set too short, to avoid any failure to trigger an alarm when the target
passes outside it.

5.4.1.5 CC (Cross Counting)

Cross Counting function counts the times for moving objects or people across the virtual
lines.
Switch: Check the box to enable the function.
Sensitivity: Set the sensitivity level. Level 1 the lowest sensitivity level while level 4 is the
highest sensitivity level.
Click Setup icon
Remove button. Click
to configure the detection conditions.
Remove All will delete all lines.
64
USER MANUAL