Group View Setup - Cobra 57648 Owner's Manual & Safety Instructions

5.8.1.2 Group View Setup

Click the add icon
1.
Click the Add IP Camera
2.
set, but each one channel can be added to 1 group only. If a channel is enabled in the
Channel View mode, it will be not allowed to add to any group.
Check the Enable box to activate the group.
3.
Set the Capacity
4.
Choose the detection target
5.
Click one of the
6.
number is 0.
Buzzer: Set the buzzer duration in seconds when the Available number is 0.
Alarm Out: If your NVR support to connect to external alarm device, you can set to emit an
alarm tone.
or setup icon
icon to add channel(s) to the group. Max. 8 groups can be
number, Start Time,
Type from Person,
to configure the alarm actions when the Available
Alarm
icons
to get to the configuration page.
End Time of each group.
Vehicle and Motion.
139
USER MANUAL