Table of Contents
Advertisement
LED Replacement
The three LED lights are accessed through the
outside top of the cabinet (not from the inside of
the cabinet).
Items Needed
LED Light Assembly (Part # P0714011V2-1) ...... 1
Phillips Head Screwdriver #2 ........................... 1
Small Step Ladder ............................................ 1
Safety Goggles ................................................. 1
Leather Gloves ................................................. 1
Soft Cotton Rags ............................................... 3
Mineral Spirits ...............................................1 Pt
Solution of Warm Water and Dish Soap ...... 1 Qt
Assistant ........................................................... 1
To replace LED lights:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove raceway covers by sliding them
off of their tracks, then lift power cord out of
raceways, as shown in Figure 44.
Figure 44. Power cord removal.
3.
Open blast cabinet door.
-36-
4.
Have assistant hold work hanger shown in
Figure 45 to avoid possibility of it falling when
(4) front cover screws are removed in next
step.
Qty
Figure 45. Work hanger location.
5.
Loosen (but do not remove) (4) work hanger
screws shown in Figure 46, then remove
remaining (8) LED cover screws.
Figure 46. Location of work hanger screws.
6.
Put on leather gloves and safety goggles.
7.
Lift LED cover, as shown in Figure 46, and
carefully pull it toward you so cover slides
out from under (4) screws. Make sure not to
break sheet of glass that is resting on rubber
cabinet seal under LED cover.
Work Hanger
Work Hanger Screws
Model G0714 (Mfd. Since 05/22)
Advertisement
Table of Contents
