Honeywell RESCU 406AFN Component Maintenance Manual With Illustrated Parts List page 91

(3) NAIM J1 pin 10 and J1 pin 11, to aircraft ARINC 429 data bus/NAV system, through
22 AWG twisted pair.
(4) NAIM J1-pin 13 (Bspeed), to:
(a)
(b)
D. Programming NAIM
(1) If a 24-bit DIP switch module is used to program the NAIM with 24 BIT Aircraft Address
then proceed as follows:
(a)
(b)
(c)
E. For NAIM module wiring to optional DIP switch module, refer to Figure A-2.
5. Installation of Remote Panel
A. Install the remote panel in the cockpit panel of the aircraft and fasten it to the standard rail
configuration, using the quarter turn Dzeus fasteners (already installed on the remote panel) to
lock it firmly in place.
B. Make sure that there is enough space behind the cockpit panel for the connector and associated
wiring at the back of the remote panel.
© Honeywell International Inc. Do not copy without express permission of Honeywell.
COMPONENT MAINTENANCE MANUAL
1152682
J1 pin 14, if low speed (12.5 kB) ARINC data is provided, or
J1 pin 13 to Open circuit, if High speed (100 kB) ARINC is provided
Connect J1 pins as shown in Figure A-2.
Program the NAIM with the BMP programming tool, with either the;
1 Standard Location NULL Message, or
2 User Location NULL Message
If no 24-bit DIP switch module is used, then the NAIM shall be programmed with
the BMP programming tool with one of the following protocols:
1 Serial Number, User Location protocol
2 24-BIT Aircraft Address, User Location protocol
3 Aircraft Operator and Serial number, User Location protocol
4 Aircraft Nationality and Registration, User Location protocol
5 Serial Number, Standard Location protocol
6 24-BIT Aircraft Address, Standard Location protocol
23-24-02
Page A-4
Oct 27/06