Table of Contents
Advertisement
Chapter 2 Installing the Tap
8
Using a small cable tie, secure the twisted-pair sheath to the bottom of the PDU.
Note: The width of the cable tie must be 0.150 in. (3.8 mm) or less. Suggested
cable tie materials are listed, in descending preference, as follows:
Stainless steel
Halar (fluorocarbon - ECTFE)
Tefzel (fluorocarbon - ETFE)
High-density polyethylene
Weather resistant polypropylene
9
If installing PTCs, proceed to step 10.
If PTCs are already installed (part numbers 750595 and 750596), proceed to step
12.
10 On the desired port, insert PTC, part number 592049, into the appropriate PTC
guide slot as shown.
44
CAUTION:
Be sure to use a high-quality cable tie that is flame-resistant as well as
resistant to ultraviolet light, chemicals, and temperature extremes.
WARNING:
Avoid electrical shock. AC power is present on the PTC during installation.
Do not touch exposed metal on the PTC. Use the plastic covered PTC.
CAUTION:
When inserting PTCs, please use extreme caution to prevent unwanted AC
power transmission on the twisted pair.
4013399 Rev C
Advertisement
Table of Contents
