To Attach The Faceplate To The Housing - Cisco Surge-Gap Multimedia Tap Installation And Operation Manual

Back View:
2 Press the PDU onto the back housing of the tap.
3 Remove the grounding wire assembly from the PDU bolt clearance hole and
attach this end to the faceplate drop port F- connector.
4 Proceed to To Attach the Faceplate to the Housing (on page 35).

To Attach the Faceplate to the Housing

Follow these steps to install the faceplate to the housing.
1 Carefully install the tap faceplate to the front of the PDU. Using the longer
faceplate bolts, tighten the 3/8-in. faceplate bolts from 50 in-lb to 60 in-lb (5.6 Nm
to 6.8 Nm).
4013399 Rev C
Installing the Coax PDU
35