Cisco Surge-Gap Multimedia Tap Installation And Operation Manual page 57

5 Simultaneously, push the ends of the two twisted pair wires through the small
holes and into the respective hot and ground connectors.
Note: The connector is labeled HOT and GND.
6 Press down on the IDC connector until it is fully seated.
7 Continue with additional twisted pair connections if necessary, and then proceed
to the next step.
4013399 Rev C
CAUTION:
If installing the Twisted Pair PDU with PTCs installed (part numbers 750595
and 750596), use extreme caution when inserting the IDCs, to prevent
unwanted AC power transmission on the twisted pair.
Installing the Twisted Pair PDU
43