Table of Contents
Advertisement
Installing the Twisted Pair PDU
Follow these steps to install the Twisted Pair PDU.
Note: Several manufacturers make coextruded cable with coax, twisted pair, and
messenger wire in one common jacket. It is necessary to use this type of wire for
proper strand (aerial) installation. For underground installations, it is acceptable to
use cable without the messenger wire.
Important: If you are installing the twisted pair version without PTCs installed, do
not insert the PTCs before you begin your installation procedures. This will result in
AC power transmission on the subscriber drop during installation.
1
Using a 3/8 in. wrench, remove the faceplate from the existing tap by loosening
the 3/8-in. faceplate bolts. Refer to To Remove the Faceplate (on page 20).
2
Remove the longer faceplate bolts attached to the plastic protective cover of the
PDU. Replace the shorter bolts removed from the faceplate with these faceplate
bolts.
3
Remove the plastic protective cover from the Multimedia Tap faceplate.
4013399 Rev C
CAUTION:
Be careful not to disturb or damage electrical components.
Installing the Twisted Pair PDU
37
Advertisement
Table of Contents
