Table of Contents
Advertisement
Chapter 2 Installing the Tap
Installing the Coax PDU
Follow these steps to install the Coax PDU.
1
Ensure that the PDU AC power switches are in the "OFF" position. If the PDU is
"ON," use a flat-bladed screwdriver to turn the switch off. Refer to the
illustration below for location of the "ON" and "OFF" positions of the AC power
switches in the 8-way PDU.
Important: It is important to perform this step now in order to prevent
unwanted AC power transmission on a subscriber drop during installation.
2
Using a 3/8 in. wrench, remove the faceplate from the existing tap by loosening
the 3/8-in. faceplate bolts. See Removing the Faceplate (on page 20).
3
Remove the longer faceplate bolts attached to the plastic protective cover of the
PDU. Replace the shorter bolts removed from the faceplate with the existing
faceplate bolts.
4
Remove the plastic protective cover from the Multimedia Tap faceplate.
32
CAUTION:
Be careful not to disturb or damage electrical components.
4013399 Rev C
Advertisement
Table of Contents
