Table of Contents
Advertisement
3
Remove the grounding wire assembly from the PDU access cover bolts and
attach this end to the faceplate drop port F-connector.
4
Proceed to To Attach the Faceplate to the Housing (on page 35).
To Attach the Faceplate to the Housing
Follow these steps to install the faceplate to the housing.
1
Carefully install the tap faceplate to the front of the PDU. Using the longer
faceplate bolts, tighten the 3/8-in. faceplate bolts from 50 in-lb to 60 in-lb (5.6 Nm
to 6.8 Nm).
2
Remove the grounding wire assembly.
3
On the desired port, turn the switch from the "OFF" to "ON" position using a
flat-bladed screwdriver. The switches are marked with the port numbers.
4013399 Rev C
WARNING:
Please use extreme caution when turning the switch "ON" and "OFF" to
prevent unwanted AC power transmission on a subscriber loop.
Installing the Twisted Pair PDU
41
Advertisement
Table of Contents
