AEG BSE892330M User Manual page 57

Problem
The oven does not heat up.
The lamp does not operate.
The display prompts to set
the Language
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display prompts to set
the Language.
The appliance does not re-
tain the water drawer after
you insert it.
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
Possible cause
The fuse is blown.
The lamp is defective.
There was a power cut lon-
ger than 3 days.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
There is an electrical fault.
You left the dish in the oven
for too long.
The demo mode is activa-
ted.
You did not assemble the lid
of the water drawer correct-
ly.
You did not assemble the lid
of the water drawer correct-
ly.
You did not assemble the
wave-breaker correctly.
ENGLISH
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
WARNING!
Refer to "Be-
fore first use"
chapter.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Turn off Demo in Menu: Ba-
sic Settings: Demo.
Activation / deactivation
code: 2468.
Assemble the lid of the wa-
ter drawer correctly.
Assemble the lid of the wa-
ter drawer correctly.
Assemble the wave-breaker
in the body of the water
drawer correctly.
57