Fire/Co Alarm System; In Case Of Fire; In Case Of Carbon Monoxide Alarm; Silencing A Fire/Carbon Monoxide Alarm - Honeywell Lyric LCP300-L User Reference Manual

Your fire alarm system (if installed) is active 24 hours a day, providing continuous protection. In the
event of an emergency, the installed smoke, heat and/or carbon monoxide detectors will
automatically activate your security system, triggering a loud, intermittent tone from the
touchscreen. The sound alternates with the voice announcement, sounding every 15 seconds. A
"FIRE" or "CO" message will appear at your touchscreen and remain on until you silence and clear
the alarm display.

In Case of Fire

1. Should you become aware of a fire emergency before your detectors sense the problem,
go to the Gateway
alarm will sound and an alarm will be transmitted to the central station (if programmed to
do so).
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify your local Fire
Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the alarm. The zone number
of the zone(s) in an alarm condition will appear on the touchscreen.

In Case of Carbon Monoxide Alarm

1. If a high level of carbon monoxide is detected you should evacuate all occupants from the
premises and immediately move to a location where fresh air is available, preferably
outdoors.
2. From a safe area, contact your central monitoring company for further instructions.

Silencing a Fire/Carbon Monoxide Alarm

1. Silence the alarm by entering the Master User code.
2. To clear the alarm, enter the Master User code again.
3. If the touchscreen indicates a trouble condition after entering the Master User code a
second time, check that smoke detectors are not responding to smoke- or heat-producing
objects in their vicinity. Should this be the case, eliminate the source of heat or smoke.
4. If this does not remedy the problem, there may still be smoke in the detector. Clear it by
fanning the detector for about 30 seconds.
5. When the problem has been corrected, clear the display by entering Master User code
again.

Fire/CO Alarm System

and press the Emergency
57
button and then select the Fire icon. The