Honeywell Lyric LCP300-L User Reference Manual page 49

5. Unplug the battery and remove it as seen below.
6. Install the replacement battery; remember to replace the connector inside the battery
compartment.
7. Depending on your choice of a standard- or high-capacity replacement battery,
position the battery retainer clip as seen below.
8. Close the case and replace the screw shown in Step 4.
9. Return the Controller to its mounting location.
10. Press OK on the battery installation procedure screen.
11. The system confirms "Battery successfully installed".
12. Press OK. The system returns to the Advanced menu.
13. Press  to return to the previous screen(s).
Sensors
Clear sensor low-battery warnings by entering a user code on the Controller. Follow the
sensor's battery replacement instructions.
NOTES: •
For SiX™ series smoke sensors, remove the battery and wait for 2 minutes before
installing the replacement battery. (?)
• For other SiX™ series sensors and wireless keys, remove the battery and wait
about 10 seconds before installing the replacement battery.
49
Need New Graphics