Fire/Co Alarm System; In Case Of Fire; In Case Of Carbon Monoxide Alarm; Silencing A Fire/Carbon Monoxide Alarm - Honeywell Lyric LCP300-L User Reference Manual

Your fire alarm system (if installed) is active 24 hours a day, providing continuous protection. In the
event of an emergency, the installed smoke, heat and/or carbon monoxide detectors will
automatically activate your security system, triggering a loud, intermittent tone from the Gateway
and the mobile device when using the MyHome Gateway App. The sound alternates with the voice
announcement, sounding every 15 seconds. A "FIRE" or "CO" message will announce on the
Gateway, or appear on the MyHome Gateway screen and remain on until you silence and clear the
alarm display.

In Case of Fire

1. Should you become aware of a fire emergency before your detectors sense the problem,
go to the Gateway touchpad and press Emergency
sound and an alarm will be transmitted to the central station (if programmed to do so).
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify your local Fire
Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the alarm. The zone number
of the zone(s) in an alarm condition will appear on the MyHome Gateway screen.

In Case of Carbon Monoxide Alarm

1. If a high level of carbon monoxide is detected you should evacuate all occupants from the
premises and immediately move to a location where fresh air is available, preferably
outdoors.
2. From a safe area, contact your central monitoring company for further instructions.

Silencing a Fire/Carbon Monoxide Alarm

1. Silence the alarm by entering the Master User code.
2. To clear the alarm, enter the Master User code again.
3. If the MyHome Gateway App screen indicates a trouble condition after entering the
Master User code a second time, check that smoke detectors are not responding to
smoke- or heat-producing objects in their vicinity. Should this be the case, eliminate the
source of heat or smoke.
4. If this does not remedy the problem, there may still be smoke in the detector. Clear it by
fanning the detector for about 30 seconds.
5. When the problem has been corrected, clear the display by entering Master User code
again.

Fire/CO Alarm System

Emergency and then press Fire Emergency Emergency
58
Fire Fire. The alarm will Fire