Honeywell Lyric LCP300-L User Reference Manual page 8

Security Features
NOTES: • For the Lyric Gateway to report alarms over the internet, your Wi-Fi network MUST
have power at all times.
• You must arm your security system in order for it to sound alarms.
Sensors and Your system's sensors are assigned to numbered
your home. For example, the sensor on an entry/exit door might be assigned to Zone
Zones
03, a device in a bedroom to Zone 06, and so on.
When alarms or trouble conditions occur, you can find information about the zone
number and a description of the sensor involved using the MyHome Gateway App.
[Home > Security > Tools . Master User Code >
Fire Fire protection is always active when the system is operating normally. An alarm
Protection sounds if a fire condition is detected. See
information about fire protection, smoke detectors and planning emergency exit
routes.
Carbon Carbon monoxide (CO) detectors, if installed, are always active and sound an alarm if a
Monoxide carbon monoxide condition is detected. See
Burglary Gateway provides HOME and AWAY burglary protection.
Protection
HOME mode protects windows and exterior doors, allowing you to move around inside
your home without setting off an alarm. (This mode may be referred to As STAY mode
in Total Connect.)
AWAY mode protects the entire premises, including interior motion detectors, if
present.
Both modes offer an entry delay period that allows you to reenter the home without
setting off an alarm. For long periods such as vacations, the entry delay can be turned
off while arming the system.
Gateway also allows you to Bypass selected sensors before arming the system.
The system also features Chime mode, which can alert you to the opening of protected
doors and windows while the system is disarmed.
Security At the time of installation, the installer asks the homeowner to choose a personal
(User) 4-digit security code, known as the "Master User code".
Codes
Other users can be added, typically with less control over the system than the Master
User. See
A user code is required when arming or disarming and for some other functions.
User Code If "X" invalid user codes are entered, the system locks out additional code entry
Error attempts for a period of time. Additional user code entry attempts will not be
(Keypad accepted until the lock out period ends.
Lockout)
NOTE: The system can be Quick Armed while in Lockout mode, but cannot be
disarmed.
Alarms Alarms are signaled by the internal sounder's on the Gateway Touchpad and on the smart
devices running MyHome Gateway App. (Alarms will also sound on external sirens if used).
The Gateway Touchpad's status shield and Alert blink red; the MyHome Gateway App
screen indicates Alarm and shows the zone(s) where the alarm has occurred. After 15
seconds, the sounder stops temporarily and the system begins voice announcements of
relevant zone information.
After the zones are announced, the panel's sounder resumes sounding. Alarm sounds
and voice announcements alternate until the system is disarmed or until alarm bell
timeout occurs. If the system is connected to central monitoring, an alarm message is
sent.
To silence the sounder, disarm the system. The zone(s) causing the alarm remain
displayed on the MyHome Gateway App screen, indicating Memory Of Alarm an Alarm is
held in memory. See
of alarm.
Audio Alarm Allows your central monitoring station to listen to or talk with individual(s) on the
Verification premises (if programmed to do so).
Users and Security Codes.
Clearing an Emergency Alarm
8
zones that correspond to areas of
Events]
Fire/CO Alarm System
Fire/CO Alarm System
for more about clearing memory
for important
for more information.