Table of Contents
Advertisement
How to Upgrade Full Image Remotely
Users can use the following command to remotely upgrade full image. Make sure you have prepared
TFTP server. The commands are listed as below.
Command
(Master)
Type command as below –
-Admin> system upgrade <tftp server ip>
<F/W file name>
(Slave – IVD module)
Type command as below –
-IVD> system upgrade <F/W file name>
<tftp server ip>
(Slave – DSL module)
1.
Enter DSL module from IVD.
-IVD> dsl –c
Connect to DSL Console...
Press <Ctrl-\> or <Ctrl-Z> to return.
2. If current firmware version is below V2.10.2.4
1) Upgrade CP file
$firmware upgrade [-]<source file>
<CP|DP|FD|DSL|ALL> <server ip>
Example-
$firmware upgrade -CP-A24-A-1GE-2.10.2.8.bin.gz CP
<server ip>
2) Upgrade image file
Example-
$firmware upgrade -DSLImage-A24-A-1GE-2.10.2.8.all
ALL <server ip>
* If current firmware version is above V2.10.2.5
$firmware upgrade -DSLImage-A24-A-1GE-2.10.2.8.all
ALL <server ip>
$reboot
16
Description
<tftp server ip> IP address of TFTP server.
<F/W file name> ex. IVD_V3.1.17.2.all
<tftp server ip> IP address of TFTP server.
<F/W file name> ex. IVD_VOIP_V1012.all
Switch CLI mode to DSL module.
<server ip> IP address of TFTP server.
Reboot from Default mode
Quick Start Guide for VigorAccess IVD
Version: 1.2
Advertisement
Table of Contents
